1⁄35How to Make Anti-Skate Plating
First you have to insert some waste kit sprues or other plastic material in nitro thinner. After some days you will get a thick plastic liquid. It consistency should be like honey. Next you have to buy one photo etched anti skating metal sheet (it is used as master and lasts a whole plastic-modelers life!).
The plastic liquid must be poured onto this metal sheet in a thin film and after two days it will get solid. Finally one only has to remove carefully this thin plastic foil with a sharp knife. (If the metal is prepared with oil, the removing procedure is easier.)
Copyright ©2021 by George Schachinger. Images and/or videos also by copyright holder unless otherwise noted. The views and opinions expressed herein are solely the views and opinions of the authors and/or contributors to this Web site and do not necessarily represent the views and/or opinions of Armorama, KitMaker Network, or Silver Star Enterrpises. All rights reserved.