I'm currently working on Tamiya's 2cm Flak 38 Quad AA. (Can't believe it's a 30 year old kit already!) The seats each have three round indendations, were there holes in them? Should they be drilled out?

hey,

this one appears to be solid.

http://upload.wikimedia.org/wikipedia/commons/thumb/0/05/Flakvierling-38-20mm-hatzerim-1.jpg/674px-Flakvierling-38-20mm-hatzerim-1.jpg

Joe

Thanks Joe, I've bookmarked the pic. It does indicate that I may have to thin out the seat a bit though, gotta check the part again. Much appreciated!