_GOTOBOTTOM
Armor/AFV: Modern - USA
Modern Armor, AFVs, and Support vehicles.
Hosted by Darren Baker
No slip M2A2 Bradley
CB1000h
Visit this Community
Pennsylvania, United States
Joined: March 01, 2006
KitMaker: 358 posts
Armorama: 304 posts
Posted: Tuesday, September 21, 2010 - 03:53 PM UTC
Hi folks

Looking for close up photo of rear deck and turret top for the no slip on the Bradley
It seams the photos in Prime portal all show the front end which by the looks of it is not really covered with as much no slip as you would think
also the photos that do show some of the rear sides seam to have none particularly the left rear side. (tools and trcak stowage) The right rear (periscope side) has some and so does the rear top hatch and none that I can see on the turret at all

I know the general rule is all horizontal flat surfaces but it seams to be the exception here

Any help would be great
majjanelson
Visit this Community
South Carolina, United States
Joined: December 14, 2006
KitMaker: 1,355 posts
Armorama: 979 posts
Posted: Wednesday, September 22, 2010 - 05:20 PM UTC
Wayne,

I've searched and lo, and behold, I found a M2A3 Bradley WIP post on Armorama that has some images showing the antislip on the turret and rear of the hull. Just scroll down about a third of the way and you will see them. Pete Becerra ("epi") is the Armorama member who provided them.

I hope this helps you out some...
CB1000h
Visit this Community
Pennsylvania, United States
Joined: March 01, 2006
KitMaker: 358 posts
Armorama: 304 posts
Posted: Thursday, September 23, 2010 - 01:14 PM UTC
Thank you
That works even though its an A3
 _GOTOTOP