I've almost finished a 1/35 Dragon Sdkfz 234/4.
I had a serious problem with the gunshield, some of you might know it has two layers plus a piece of photo etch in the centre.
In my case, the photo etch was down too far (I followed the instructions too! ) and pressed against the gun and therefore the shield didn't fit properly.
Well, I took some cyanoacrylate debonding stuff and tried to undo it.
Things went completely pear shaped and I'm hoping someone knows where I might be able to find a replacement for the two shield halves.
WarWheels Forum
This forum can be used for all topics and discussions on WarWheels!
This forum can be used for all topics and discussions on WarWheels!
Hosted by Al Crawford, Patrick Keenan
Dragon 1/35 Pak40 shield needed. Help!
CardinalPugwash
Australia
Joined: November 24, 2010
KitMaker: 4 posts
Armorama: 2 posts
Joined: November 24, 2010
KitMaker: 4 posts
Armorama: 2 posts
Posted: Wednesday, November 24, 2010 - 12:45 AM UTC
CardinalPugwash
Australia
Joined: November 24, 2010
KitMaker: 4 posts
Armorama: 2 posts
Joined: November 24, 2010
KitMaker: 4 posts
Armorama: 2 posts
Posted: Wednesday, November 24, 2010 - 02:51 AM UTC
NO NEED TO REPLY.
I FOUND WHAT I'M LOOKING FOR.
I FOUND WHAT I'M LOOKING FOR.