How does zimmerit work when there are tool brackets (like the side of a tiger 1)?Is the zim applied around the brackets or over them or any third choice? Pix would be great! Thanks for your help!

Hi Anthony!
The pattern was rolled into all the open spaces around the bracket or clamps, then over-rolled to fill in the missed sections. Where the gear tool would not fit, the pattern then appears to be applied using a trowel/spatula. Around the Kugelblende, rear hull obstructions, Bosch lamp bracket, Mantlet, and around the lifting lugs on the forward portion of the Turret sides.











Drop me a line if you need anymore, info on the techniques.

Cheers Phil.

Thanks Phill! One question: I'm using Milliput and can't figure how to mask the areas where the brackets and such should go. Any suggestions?