Alright, the designing of the Bar armor is almost complete. I just need info on the rear panel; how it mounts; how it locks closed with the ramp up, door closed; etc. Everything else is finished and looking good. I am ready to send the drawings off to my etcher to get the sets produced, other than the rear section is completed. Thanks for any help anybody can provide!?!?
As a side note, I also did receive the masters/molds for the M113A1/A2 from Milliminis as well. I look to start producing these sets soon as well.
I also plan on releasing a correction set for Academy's M11A3 to make it more accurate.
Lots of plans, so little time!
Cory Sutton
CSM Designs
Hosted by Darren Baker
M113A3 Bar Armor

corsutton

Joined: June 17, 2005
KitMaker: 544 posts
Armorama: 511 posts

Posted: Friday, January 13, 2012 - 05:29 AM UTC

sauceman

Joined: September 28, 2006
KitMaker: 2,672 posts
Armorama: 2,475 posts

Posted: Friday, January 13, 2012 - 05:32 AM UTC
Send me your e-mail via PM and I will send some pics and stuff to you.
cheers
cheers
![]() |