I need a bit of help here if anyone can oblige. I've near enough completed 2 SAS jeeps for a North Africa dio I'm planning. The problem is I have no idea how the condensers were plumbed in to the radiator. I've got a third jeep I was debating doing with the bonnet up so naturally on that one you'd be able to see where the pipes go. Any answers anyone?

hope this helps...the same question was asked on another modelling forum, all the replies agreed that the condenser hose would have connected to the radiator just below the filler cap. but it was also noted that as these were field mods by men who were good at improvisation.

Hi,

have a look at this site http://www.lrdg.de/vehicles4.htm

There is a nice picture from the water contenser.

By, bye

Stefan

This might be of help.

WWII Jeep Desert Cooling

or this

Mounting the Surge Tank