I have just started this kit and ran into trouble with the instructions. In step #1 you are to make a quantity of four parts A-38 attached to disc shaped parts. These are numbered as A-42, A-43, A-44 and A-45 on the trees. There is a raised bar that slants either to the left or the right across the faces of these. However they are marked as
A21(A55) on the instructions. Which is not these discs but are the boggies. Can anyone untangle this mess and tell me here these parts go together and if the angled bars have to slant towards the front or rear of the tank when attached to the boggie mounts????? The kit is DML no. 6439.

Contact me directly at [email protected] instead of on this forum and thanks in advance for any help.

Ray Mehlberger