Is there a more common arrangement for seats in the back of the Maxxpro? Kinetic shows 2 per side but has placement holes for three per side,as well as 6 seats. What few pics I have seen seem to show just 4 with the empty areas being used for stowage. Was there a specific seat that would be removed on each side or was is just based on mission or preference or something? Just trying to figure out the best positions to install seats. Thanks

the REF i found on the internet tells me that most the time 2 on the left and 2 on the right......the duke box could be installed on ether side.

Check this out
Ralph Zwilling's site mrap walk around
http://tank-masters.de/?page_id=885

And more



















Jay

Nice posts....Bookmarked for later use. Thank you!!

Thanks- based on what you posted and what I found, it looks like its common that on the left, the closest seat to the front is removed and on the right, the rear most one is removed.

My references (I took quite a few) show the same arrangement.

Thanks...I was using your CD last night and that's what I saw.

Looking more, in the pics it looks like the Duke box replaces one of the seats. The Kinetic instructions show it being added on the left back, but not where any seats go. Is both possible or is Kinetic incorrect?

Thank you Jason!

I do not know nothing about the correct positions of duke box. BTW, this post will be very, very useful when I build my MaxxPro

Cheers!

Marco

Both way, look at those 2 pics above shot from behind the maxxpro, you can see the box's installed on the left side, one of them is facing side way, Also, Ralph's walk around shows the same thing.

jay