I am getting into the mid-phase of the tractor construction for the HobbyBoss HET kit, and see that the photo-etch requirements are finally starting to kick in. There is a problem though that I located in the directions: many of the PE illustrations do not actually show what bends, etc are required to complete the piece for installation.

The various illustrations show the pirce but the picture is so small that I cannot deciher what I need to make it complete.

Does anyone have any photos or work plans that they devised to address this? It's a very challenging model, yet very satisfying in just how well it goes together. I am NOT looking forward to all of the air hose construction for the trailer though!

You might check out some of the builds by PavelS or bulivyf They have done some amazing work on the M1070 HET.
Here is a link to bulivyf's build. https://armorama.kitmaker.net/forums/186535&ord=&page=1