I am in trouble. I am bulding the Takom 1/16 model
builidng the engine, I am confusde where about to put what looks like an oil barrel: there are two holes that would corresponde to the two pins on the barrell and instructions shows to put it there. But I f it Put the piping in place, the barrel cannot fit. If I fit the barrel first, well, viceversa.
photo might explain bettre than my pigeon english


Any tip?

Doesn't get much better than this

from this build log

AFAIK, the official designation is Renault FT

HTH

H.P.

I need to aplogie to everybody. This is the evidence of how sometime we modellers complicate our lives by ourselves. Only after reading a few replies....i remembered i had actually closed the gap under the barrel with Milliput as , when i saw it, i tought "....mhhh, it might be viseable, let's close it".  I did, and probbably too smoothly, and then i forget. All sorted now, thanks for your help