I'm about to start the Tamiya Quad Gun Tractor and I would like to show some damage to one of the front wheel arches / mudguard as though it had run into, or hit something.

Can someone offer any advice how to do this, please?

Thanks

Andy

Hi Andy

One way would be to use the model part as a former to make the wheel arch from tin foil. The type that's used for carry out meals. Then dent as you wish I would say that's it or thin down the model part and carefully apply heat to dent the part.

Good luck

Or, depending on the damage, use a Dremel to hollow out the inside of the kit fenders until they are paper thin and damage them as you like.

Thanks for the replies Wayne and Paul.

As I don't yet own a Dremel, I'll try the tin foil method to start.

Best Wishes

Andy