Having purchased the Trumpeter 1/35 SS-1C Scud B I was wondering if there was any interest in starting a post on adding any missing details /errors on the model of this system? I've noticed a couple of omissions myself and thought it might be good if others could chime in in with what they know so that all of us who have this kit and want to improve it can.

What do folk reckon?

Regards,
Andy

Andy, sounds good will follow when you start the build thread.

Ok. Not started build yet but still gathering info. Here's what I've noticed so far:

There are two access panels missing on the top of part L2



The plug fitting that is attached to the support frame , part G46, is missing, as is it's associated cabling which runs across the drivers cab and into the roof



Pictures of in service vehicles show a pressure vessel fitted to the left side of the hull next to the air inlet.



Pictures also show mesh netting on the forward part of the erector cradle.



Also all of the piping and cabling of the erector hydraulics is missing, I'm still trying to work out what goes where. Same with cabling associated with the missile (especially if you want it in launch mode)

Anyone else like to add anything?

Regards,
Andy