Slowly I collect KTM-6
Now he in such state

One party of KTM-6 is almost ready
It is possible to be engaged in the second party

This seems to be turning out very well!

Here's a couple of questions for you, is this entirely scratchbuilt or based on an existing kit?

What are you going to use it on?

What references are you going to use for the hydraulic piping?

Happy modelling!

Hi;

It Looks like from the pictures, that its Trumpeter's KMT-6; Which is not accurate as it only has one side of the Hydraulic lifting assembly complete. The only Accurate KMT-6 is Miniarm's or the Zedval set.

CHEERS; MIKE.

All the good days
The basis is taken from the KTM-6 Trumpeter
Everything else is done on the basis of photographs
Of addition plastic, wire, bolts and nuts from Meister Club
To build this model was bought by a second set of KTM-6

Few fresh photos of KTM-6

I have finished with cables and a hydra cylinders

Hi Michi!
Impressive work. However, you should check the direction of the tines to the travelling direction: On your pictures, it looks as if the tines of the plows are not parallel to the driving direction, which is a MUST.

Eine beeindruckende Arbeit. Bitte überprüfe die Richtung der 3 Zähne je Pflug zur Fahrtrichtung. Auf den Bildern sieht es so aus, als wenn die Zähne nicht parallel zur Fahrzrichtung stehen sondern schräg nach außen. Die Zähne müssen parallel zur Fahrtrichtung stehen. Nur so können sie durch den Boden schneiden.

Greetings, Andreas

Hi Mike,
I am aware of a KMT-6 of SKIF which also has some issues with details. Just have located Zedval (thanks to your comment). But, is a KMT-6 from Miniarm available? I have seen for some years now a CAD rendering on their intro, but have not noticed that this set is on offer from them.

Thanks for your comment!
Andreas

Hello Andreas,
the Zedval and Miniarm plows are both KMT-8, not 6.

Sean

Few fresh photos of KTM-6

New set to help fix the Trumpeter KMT-6 kit: SAAMMODELS

In my opinion, this set should be completed also