in my personal view, the biggest problem constructingtrumphy zsu-57-2 was trying to align 4 clip 14 rows of ammo in both side of the turrent.

Just be glad you never tried making the ammo clips on the Jadar resin kit.

I might see if I can use the Jadar etch bits on the Takom kit.

Andy

It is not symmetrical ! On the left, 56 ( 4x14 ) during the radio right side of 40 ( 4x10 ).

Direction of travel , rear right: 20 ( 5x4 )
sidewall review : 8 (4 + 4)
During Radio: 40 ( 10x4 )
Front corner : 8 ( 2x4 )
Front: 4
At the rear left side of the inner part : 12 ( 3x4 )
External area : 12 ( 3x4 )
Sidewall review : 4
Underneath , on page 56 ( 14x4 )
Front, corner 8 ( 2x4 )
Front: 4.
Full on turret 176! :-D
Total: 300, and filling line + 4-4... (312)

other problem is G-35,(see page 16) is too long.

do anyone constructing takom zsu-57-2 encounter similiar problem?

Something is not right ...
Rules of drawing is not good.
Photobucket counted : 14-14 stripper clip is on both sides , to give Takom 12-12.

Total ammo the turret (visible) 180! And symmetrical !

original book draw.

real vehicle, right and left side.

That manual drawing doesn't seem to match reality?

Andy

This is "parallelogram rod", gun height movement of the reticle sets array.
This can be adjusted horizontally you set the cannon tubes , and the horizontal sighting devices also measure the distance ( Caliper ) between the two connection points , and accordingly converts the length of the rod . the two connection points on the component portion when grunts ( drilled and supply of axles if not solved ) , you move up and down the tubes , the reticle will move with it ( attention, to move forward and backward ) .

But, is not accurate drawing.

12. page: G-40 + G-28 do not glue!!!!
13. page: G-11 and G-31 bath , and put a hole located wire.
16. page: G-18 Sight Spike only the left barrel!
G-35, right barrel upper side and sight connection points , put a hole located wire.

Agree.

Andy