Would the RFM M1A2 interior fit the Meng M1A2 TUSK kit? If not, what would have to be done to it to make it fit?

I've seen the electronics laid on a table but not installed, and they're a little different. Yet I'd like to think a Tusk upgrade would include all the M1a2 electronics. Yet the M1a1 was a little different in target acquisition and tracking targets. I'm sure there's more yet, and perhaps Gino or one of the young guys will chime in here. Been ten years since I last saw them, and later found out my security clearance wasn't good enough.
gary

Michael, I'm sure with small adjustments you could get the RFM M1A2 interior to fit the MENG M1A2 TUSK. There should not be that much difference between the two as they are models of the same vehicle. The RFM kit has mounting points and some detail molded all over its interior though.

Regards,

Eric

Ok, thanks. If I can get the parts I'll try it.