I'm in the middle of putting the new PSM dozer kit together, adding it to the Dragon M48A1.

The small build sheet does not really give adequate information/detail to allow me to make sure items are going together properly and in the proper places.

I managed to get the hydraulic lines that run from the rear deck along the right side, and then to the lateral spread bar in front of the driver's hatch. I also carved the front of the lower hull away and fitted the large one-piece casting with the dozer mounts.

I'm trying to use brass rod to pin the various swivel joints together, and some of the connections are challenging to get a pin vice into, keeping the drilling straight and level as best I can.

Any detail images of the hydraulic lifts, blade locking linkage
and any other material would be greatly appreciated.

Maybe you could use the TM for the M8A3 bulldozer as a guide.

KL

How different is it from the dozer mount on the M728?