OK, can anyone help me with the radio/electronics locations inside the Maxxpro Dash? I am building the Panda kit and have the Blast models MRAP radio set as well as the SINCGARS/ASIP and Duke electionics from Shapeways, but I really don't know where most of it goes. I have Rob Skippers pics, but one interior set has the radios removed and the other interior set of pics only has one side shot of the radio rack

Yes i would also be very intreasted in that, have not found any photos on internet so far...

The Duke Control box is usually in the rear left corner and the remote control box would be somewhere up front attached the dash board.. The AN/VRC-110 HARRIS radio would be on the platform between the driver and passenger. The CPU for the FBCB2 would be in the radio rack along with a SINCGAR set up if so equipped.

Thank you

You can also find some info in this
MaxxPro interiors thread.

I was TC of a gun truck in OIF in 09, no harris radios but the mount was there. Dagger was upper center of the TCs windshield. FBCB2 screen in front of TC seat. Drivers DVS screen above driver. SincGars radios were on rack behind the driver, in passenger compt... directly opposite what I recall was the a/c-heater. The racks were in line with the gunners foot pedestal about a foot an a half above that..... between rear of drivers headrest and the first seat in the passenger area. If I can find a picture of it Ill send it along