I finally took this out of my stash and will be building it with a dio in mind

zetor1

I will be following your build with interest
That kit is hiding in my stash as well ...
/ Robin

Robin I put this off for years because it's resin but it is actually easier than some plastic kits I've tackled lately. It needs a slightly different skill set needed to styrene kits. I've replaced some resin rods replaced by stretched sprue and wire.


zetor2

zetor3

zetor5

Etch. What doesn't kill you makes you stronger

Good clean casting though the front axle had a large internal air bubble which caused it to snap when removing the casting plug. I pinned it together with some wire and superglue

zetor

zetor6

zetor7

14 seperate pieces to make up this subassembly

zetor8

zetor9

zetor10

I put a coat of primer on what I've done so far to give a clearer picture of the model

I didn't trust my sausage fingers to construct the delicate seat frame so I made one from wire

skp zetor

skp zetor

Some more progress

skp zetor

skp zetor

skp zetor

skp zetor


Decals on
skp zetor