Twenty dudes will give you twenty different combinations, and they'll all be close. I had a set that faded so badly the sand looked almost white. For somewhat faded BDUs this is what I used:
A mix of XF1 and XF2 until you you get the shade of faded black you want, XF5 for the green, which can also be lightened, XF14 (yes, I know that is gray) for the sand, and XF52 flat earth for the brown. None of the Tamiya Browns I have come close, but the flat earth looks good.
Hopefully I'll dig up the photo of the faded uniform from 1982, which still fit in 2005.

FWIW, Tamiya is the worst choice to brush paint by hand (IMO). I'd look for Vallejo matches or Humbrol for the enamel route. Personally I'd airbrush the lightest colour with Tamiya, then switch to Vallejo for the green and brown blotches and finish with the blacks crow's feet.

Jim

...
True, out of the bottle Tamiya is hard to brush paint with, but properly thinned it works just fine. I mix in a nylon pallet, 1:1 ratio with Tamiya thinner and I've never had any problems. The beauty of this is it can be reconstituted if it dries while using. Can't really do that with Vallejo.
VR, Russ

Quoted Text

---

Twenty dudes will give you twenty different combinations, and they'll all be close. I had a set that faded so badly the sand looked almost white. For somewhat faded BDUs this is what I used:
A mix of XF1 and XF2 until you you get the shade of faded black you want, XF5 for the green, which can also be lightened, XF14 (yes, I know that is gray) for the sand, and XF52 flat earth for the brown. None of the Tamiya Browns I have come close, but the flat earth looks good.
Hopefully I'll dig up the photo of the faded uniform from 1982, which still fit in 2005.

---

I remember we used to call those faded BDUs, "cook whites"...

David,
Ok I’m at my workbench now, and the four Tamiya colors I find that best match the woodland pattern (when new) are:

XF 26 Deep Green (not mid Green as I said before—Deep Green is a brighter green)
XF 64 Red Brown- not really red at all, closer to true brown
XF 78 Wooden Deck Tan—a very slightly darker shade than a true tan.
XF 1 Black

All these can be lightened with white for more variation in color. And as I mentioned before, properly thinned with Tamiya’s Lacquer thinner (yellow cap) they will brush paint just fine. I wouldn’t use any other thinner though. Hope this helps.
VR, Russ

Quoted Text

---

David,
Ok I’m at my workbench now, and the four Tamiya colors I find that best match the woodland pattern (when new) are:

XF 26 Deep Green (not mid Green as I said before—Deep Green is a brighter green)
XF 64 Red Brown- not really red at all, closer to true brown
XF 78 Wooden Deck Tan—a very slightly darker shade than a true tan.
XF 1 Black

All these can be lightened with white for more variation in color. And as I mentioned before, properly thinned with Tamiya’s Lacquer thinner (yellow cap) they will brush paint just fine. I wouldn’t use any other thinner though. Hope this helps.
VR, Russ

---

Russ that's the colours I'm running with and I will see how I get on but I've never been confident at hand painting camo uniforms

I still have my "Graf" jacket which was lined with a stolen wool blanket.
Dan

My modified snivel gear rotted away after several years use when I got out. Since I was from Washington I used it when I was out in the woods lined with blackberry brambles, stinging nettles while chasing raccoons and coyotes during a rainy cold night. My gortex still looks new 25 years on but the zipper busted a while back, and it's a bit snug around the middle. No idea how that happened .