hi all. i use the model master acryl clear flat.
on my armor. and when it dryed it dryed glossy.
i stired the hell out of it and i added a little bit of water,
and it still dryed glossy. can the bottle go bad??
or was the bottle mis marked??
i never had this problem before thanks guys

Did you use thinner to thin the flat coat? Too much thinner could have caused this problem. Also, I have recently bought a couple of MM Acryl paints that were so thinned down that the paint ran off the model and went gloss where it did stick.

yes i use a very little bit of water to thin the flat coat,..

okay, i had the same problem a while back, put a pencil all the way at the bottom of the jar and see if there is a 'gooky' mixture down there, if it is, what that is is settling pigments from the paint, you need to stir all that up and make sure no pigment is settled, mix it all in, and try again.... :
mech

ok i did the penicl thing there was
'gooky' mixture down there so it all mixed up.
and the 3 coat came out great thanks guys