I woudl like to hook up my aztek and Iwata to my compressor at the same time. I need a special "splitter" I am thinking of something that can be toggled to allow air into one AB and not the other. Suggestions as to where I can get such a piece?

You need a T-connector that allows to use with 2 airbrushes as this one on a webshop:

- http://www.hobbylinc.com/htm/tes/tes50682c.htm

HTH.

Any DIY store should be able to hook you up. You are going to need a "T" and three straights, one straight to go into the compressor and the "T" and one straight going out of the "T" to each AB. I would recommend taking your AB hoses with you to the store to make sure the pipe threads match up. And get some Teflon tape to seal the threads if you don't have it already.

Shaun