hey everyone
well, i bought a compressor some days ago. its a Testors, "the little bleu" one, you know. (its the one that "mother" gave away). when i connect my airbrush and turn the compressor on, it doesn't give enough air. how can you set the airpressure right?

thanks in advance!

gr. martijn

On the output fitting, does it have a little screw-in piece sticking out the side?...maybe with a little nut to set it in position? If so, try backing off that knob a bit.
It's hard to describe, and I'm not sure I'm thinking of the right compressor, the kind I'm thinking of is very similar to my Paasche D500.
Got a photo?

that one its a testors, and i have a revell airbrush. so when I bought it, i also bought a connection part of badger. but if you take the connection part of, there's still not coming enough air/pressure out of the output.

thanks in advance!

gr. martijn

anyone?
I just want the airpressure to increase. but how... no instructions coming with it

thanks!

gr. martijn

Martijn, I did a google search and saw that it's "supposed" to be able to hit 40psi...do you have a gauge on it, or one you can borow from a friend, to see what it's putting out? Did you try the compressor alone{no AB hooked up} to see what it puts out...put your finger over the output fitting and see how much pressure you feel against your finger..."could" be a bad unit. Did you teflon the AB hose and that other fitting you have when you installed it on your compressor? You'd be looking for leaks in other words...you never know when a given hose or fitting will decide to leak, even if they're new.

Does it have a Bleed valve, if so make sure its closed and see if the pressure increases.