I'm sorry for the slightly confusing topic, but after one mishap with the bogeys mounting height I just call her 'lowrider'.
I shortened all bogeys by 2 mm, it didn't went without problems. I shaved off lower locating tab and left the upper locating pin so the whole tank would sit 2mm lower than it should I should do the opposite, shave the pin and leave the tab, unfortunately I realised that only after all bogeys were glued in place, and I checked it with plans I have So I shaved the bogeys off hull, marked correct positions and glued them on again Its all good now, I even managed to get all the bogeys more less level other than that it went together with no problems and the fit was very good so far actually
I also post this as sort of a warning for those wanting to correct the academy suspension.

Cheers
Grzegorz

With this post I find you signature a bit ironic...

Well... it isn't ironic... or should I say 'wasn't' ? Actually I never count the rivets, which this kit has plenty of

Cheers
Grzegorz

Great post! Now all you have to do is fix about 50 rivets! (I just finished this kit in Russian Lend Lease guise!)

I sure Rob at Formations will roll out some updates stuff for this kit.

Chris

I aint touching no rivets on this one :-) I'm not mad

Cheers
Grzegorz