Has anyone used the Voyager models fender PE for the Cromwell/Centaur? I need some guidance before I trim off the Tamiya's molded fenders.
1. Are the cuts for the upper hull's fendersvertical or horizontal to remove the kits fenders?
2. On the lower hull the detail removed is on the two side plates and not on the hull bottom itself, correct?
3. After removing the fenders there are two indentations on either side of the turret the Voyager calls for the level to be raised, but to what level? Can card stock be used to be uniform? What thickness?
4. Any suggestions on making the curve for the front fenders? This is my first PE kit with curves, right angles are no problemo.