_GOTOBOTTOM
AFV Painting & Weathering
Answers to questions about the right paint scheme or tips for the right effect.
problems with white paint
Maki
Staff MemberSenior Editor
ARMORAMA
Visit this Community
Croatia Hrvatska
Joined: February 13, 2002
KitMaker: 5,579 posts
Armorama: 2,988 posts
Posted: Sunday, March 16, 2003 - 05:17 AM UTC
I've got problems painting white... The only jar of white paint that I have at the moment is Revell's enamel and it doesn't cover the surface properly. Not only that but the brush marks are fairly visible.. and that is going on my nerves..

Do you guys have a suggestion how to make a good job out of it? I tried to make several lighter layers but it doesn't get any better..

Mario M.
Stormbringer
Visit this Community
England - South East, United Kingdom
Joined: January 20, 2002
KitMaker: 1,667 posts
Armorama: 1,116 posts
Posted: Sunday, March 16, 2003 - 05:34 AM UTC
Hi Maki
I have the same problem with white paint of any kind.I think the only solutions are either to under coat the model in a light grey or to try an airbrush.But i'm fairly sure that some one else will have a better idea.
regards
Peter
scoccia
Visit this Community
Milano, Italy
Joined: September 02, 2002
KitMaker: 2,606 posts
Armorama: 1,721 posts
Posted: Sunday, March 16, 2003 - 06:50 AM UTC
If it's gloss white given vith a brush on wide areas is quite hard to manage. If it's matt I found a way to cope with that, trying first on a scrap piece of plastic first to look for the right dilution of the paint, once you've found it try to give multiple coats as light as you can. Do not expect that it covers at the first coat. You can also try with a cheap spray can, if you do not have an airbrush.
mj
Visit this Community
Illinois, United States
Joined: March 16, 2002
KitMaker: 1,331 posts
Armorama: 569 posts
Posted: Sunday, March 16, 2003 - 10:58 AM UTC
Yup, before I got an airbrush, hand brushing white paint ranked right up there with a trip to the dentist. The only way I found that looked halfway decent was to put down a primer base of light gray, to give the white enamel something to "bite" into. Even then...results varied. Things go easier with an airbursh. I haven't tried it with a spray can.

Mike

Marty
Visit this Community
Massachusetts, United States
Joined: June 16, 2002
KitMaker: 2,312 posts
Armorama: 1,054 posts
Posted: Sunday, March 16, 2003 - 02:24 PM UTC
Yup, definitely prime it first with a light color. It will help the paint adhere better and it will cover the are nicely as well.
 _GOTOTOP