TRUMPETER [ MORE REVIEWS ] [ WEBSITE ] [ NEW STORIES ]

In-Box Review
135
Russian KV-1 S Ehkranami Model 1941

by: Jim Rae [ JIMBRAE ]

introduction


Two, curiously parallel 'panics' emerged during the first weeks of the German invasion of Russia. The first, from the German side, was that they had grossly underestimated the actual numbers (and quality) of the Soviet tank forces' capabilities, the second, from the Soviet side, that German AT capability was far greater than originally envisaged. Both were in fact true. The latter from the point of view of the Soviets, led to a series of conversions to their KVs which would involve the addition of extra armor. Thus was born the 'Ekranami' program... The program essentially called for a series of bolt-on 'kits' to be produced for the KV-1 model 1940, redesignating them as the KV-1 S Ekranami Model 1941. There were two distinct variants in this program, Modification 1 and modification 2. The difference was simply that in the first, only the turret received bolt-on plates, whereas in the latter, additional armor was added to the hull sides. Modification 2 is the subject of this recent release from Trumpeter in 1/35th scale...

some preliminary comments about this review.


Unlike the other reviews I have published on the KV-1s from Trumpeter, this comes into the category of a 'first-look' . One of the fortunate aspects of the KV for the Trumpeter design team, is the commonality of components used in many KV variants. This kit is based on an earlier model from the company, the small turret KV...

trumpeter's KV-1 S Ekranami


00357 - Russian KV-1‘s Ehkranami, is a 1/35th scale kit comprising some 230+ parts moulded in a light-grey plastic. The kit, comes in the standard packaging with some nice box-art by Vince Wai - who is also (coincidentally) a long-time member of the site. Apart from the plastic components, an additional set of vinyl tracks are included along with a length of brass wire (for the tow cables). Apart from the instruction sheet, a full-color sheet is included for the color scheme and decal placement....

The kit follows the by now standard 'modular pattern' with items such as the hull-tub, upper-deck and suspension arms being common to all the models in this series. The turret is the same as provided in the 'small-turret' kit...

There are some changes, new roadwheels, the bolt-on armor and the 'square' stowage boxes are provided...

In detail...

My previous comments on the other models in this series, should in essence be sufficient so, to avoid the danger of repeating myself, I will attempt to deal with the kit's updates...

Suspension: The most notable change is the provision of new roadwheels. These are the correct reinforced (cast) type. The earlier road wheels did tend to shatter with the additional weight of the armor modules... The front idler is well reproduced although perhaps the central disc should be less pointed.

The Armor Modules
These consist of a series of armored plates bolted onto the following areas:
1) Onto the turret (two per side)
2) Externally covering the crew compartment: Two panels above the fenders and two larger sections above and behind the suspension.
3) An angled front panel increasing the armor thickness of the fromt glacis plate.
The moulding on all of these parts is first-class, with the bolt-heads well reproduced.

Stowage
A useful (and missing from some of the other KVs in this series) addition is the provision of three of the flat storage boxes seen on many KV variants. These are generally well-done (see photos) although the more exacting modeller may want to substitute them with some of the PE sets currently available. The (often-seen) padlocks on these boxes are not included...Also included is the cylindrical container which could be the storage for a telescopic, barrel cleaning-rod.

Turret
The turret scales well with the plans I have. The rear MG has the correct 3/4 'crescent' where it bolts onto the turret. The mantlet is excellent with all the correct 'holes' and bolts well reproduced and would not require replacement. The gun barrel is a good reproduction of the 76mm F-32 gun which again, should keep most people satisfied. Slide-moulding has been used to good effect to 'mask' the solid nature of the moulding.

The Nit-picks
The common factor on all of the KV models, are the plastic engine grilles and the lack of the rear hull grille. These SHOULD be replaced by PE items, as the difference is notable... I'm also not the greatest fan of the fender supports which seem a trifle on the thick side. Internal hatch detail is also lacking and some 'dressing-up' of this area would be a useful (and simple) improvement.

The Decals
Markings are provided for one vehicle - a typically 'flamboyant' vehicle with slogans. The decals have good register with the minimum of carrier film....

Conclusions

An excellent, well-researched and very competently executed model of one of the most striking of the KV variants. There are a lot of additional possibilities with this kit, to only add the turret armor produces a good model of 'Modification 1'. Even using the earlier roadwheels can also provide a slight variation... Trumpeter seem to be improving with every variant they produce of this series. I do however feel that the inclusion of the PE grilles would be a nice touch (if only for the engine grilles). The sophistication of their moulding is also improving considerably although in the case of the KV series, 'over-engineering' would be a gross mistake, Trumpeter seem to haev got the 'balance' exactly right. Once again to repeat my earlier comments, the KV series is something which deserves some serious research, it WILL look o.k. out of the box, but with a few extra details it could really become a spectacular model... This is a series for modelling, not kit-bashing....

Very Highly Recommended

Further details - references etc...


My evaluation was principally done using Jochen Vollert's superb Tankograd publication, Soviet Special Nª 2002 - KV-1 Soviet Heavy Tank of WWII: Early Variants, a review of which, can be seen: HERE

My 'Ekranami' was purchased from LuckyModel who provided their usual fast and efficient service.

In the last month or two, I have been updating 'Armor Resource Nª 2 - the KV, which has linked together all the published articles on the site covering the KV. It can be seen HERE!
SUMMARY
Continuing with my determination (obsession) to build and review all of Trumpeter's KVs in 1/35th scale, this review looks at possibly one of the more attractive variants of this most interesting of vehicles....
  SUBJECT:90%
  PRICE:100%
  MOULDING QUALITY:85%
Percentage Rating
90%
  Scale: 1:35
  Mfg. ID: 00357
  Suggested Retail: around $20
  PUBLISHED: Feb 09, 2006
  NATIONALITY: Russia
NETWORK-WIDE AVERAGE RATINGS
  THIS REVIEWER: 88.06%
  MAKER/PUBLISHER: 84.47%

Photos
Click image to enlarge
  • kv_009
  • kv_007
  • boxes2
  • boxes1
  • kv_006
  • sprockets
About Jim Rae (jimbrae)
FROM: PROVINCIA DE LUGO, SPAIN / ESPAñA

Self-employed English teacher living in NW Spain. Been modelling off and on since the sixties. Came back into the hobby around ten years ago. First love is Soviet Armor with German subjects running a close second. Currently exploring ways of getting cloned to allow time for modelling, working and wr...

Copyright ©2021 text by Jim Rae [ JIMBRAE ]. All rights reserved.


   
ADVERTISEMENT


Photos
Click image to enlarge
  • boxtoplarge
  • color_scheme
  • decal
  • 20051026102059
    Trumpeter Image...
  • hull
    Trumpeter Image...
  • 2005102610216
    Trumpeter Image...
  • 20051026102035
    Trumpeter Image...
  • 20051026102029
    Trumpeter Image...
  • 20051026102048
    Trumpeter Image...
  • 20051026102054
    Trumpeter Image...
  • 20051026102023
    Trumpeter Image...
ADVERTISEMENT