Introduction
This kit from
Voyager Model is for the DML 6330 Panzer IV Up Armored version. This is to replace the plastic version of the armor for the front and side panels along the upper hull. This kit contains approximately seventy-five pieces. It includes the panels needed to replace all the armor for the up armor along with the bolts to put them in place.
Review
The left side panels are in two parts. A forward panel (M4) and a rear panel (M2). These two panels require thirteen bolts between them. Also included in this part of the assembly is one of two hooks to be placed on the front end of the upper hull. Each of these requires two bolts plus parts R1 and R3. These simply get mounted into place.
The right hand side is very similar to the left. It includes the same hook assembly as listed above. Then M3 and M5 are used for the side panels on this side. Again, thirteen bolts are located in these panels.
The front end is the most involved of this kit assembly, it includes the bulk of the large parts for this kit. There is a pair of back panel plates (M6 and M7), seven bolts are also required for this assembly. In front of those parts is a pair of support brackets for each back panel (R2). These four parts simply get folded into three sections and installed. Then the front panel (M8), itself simply gets installed along with eight more bolts. Once those parts are in place this kit is finished.
All the holes need to be drilled out to accept the bolts.
Conclusion
This is a very simple PE set and is a very nice representation of the armor that is a part of the up armored version of the Panzer IV. It is designed to go along with several others from Voyager to replace the armor and other parts from DML’s kit number 6330. The other kits include PE35080, PE35303, PEA173, PEA175, and VBS0135.
Related Reviews:
PE35303
PEA175
PE35017
Comments