review

This kit is pretty straightforward with a minimum of assembly required. The three cast pieces are each on their own block. The detail is well rendered including the rivot heads securing the slats to the cross members. There were a couple minor air bubble holes that were easily filled and sanded. Parts came off their casting blocks with the help of a small razor saw, and cleaned up with a sanding stick.

The assembly instructions consist of a hand-drawn, exploded view of the parts. The three pieces were glued together using a medium viscosity CyanoAcrylate glue, and quick set with Jet Set. The only word of caution I would offer is to make sure that the runners are squared up well as not to look lopsided.

I primed the finished piece with Plasticote gray, sandable primer. Then I applied a basecoat of Vallejo acrylics, and weathered with oils.

conclusion

This kit is definitely a good primer for those new to working with resin. It’s easy enough to assemble without getting frustrated, and the parts aren’t so fragile that you would worry about breaking them. The end result is a nice representation of a sledge, and would be useful for hauling supplies, pulling a wounded soldier, or even riding for fun! You will most likely want to drill some small holes at the front and add your own rope to finish it off.