I have a couple items I need/want/would like to see printed.

First is a set of about 8-10 1/35 modern tank towing pintles. They look like this:




They would not need the wings on either side of the shaft, nor the bolt on the end. Just the flange near the pintle end as the shaft is to be inserted into a hole in the mount.

Second is a long shot, but probably (hopefully) doable. I would love a printed rear frame section to convert the Hobby Boss Delta Force FAV into a SEAL FAV (like below).




I have some better drawings I can send you if you want to move forward with it.

Any chance of a M243 four-barrel smoke grenade launcher in 1/35 and 1/16?

Thanks

I've been working on a few Pintle hitches for a couple days over the past few weeks. My semester has ended so I'll have much more time to work on them. I'll estimate that they should be finished in the next few weeks.

I did not scroll through all the responses so I apologize if this is redundant, but I would like to see Blue Force Tracker receivers/antennae.

Quoted Text

---

Any chance of a M243 four-barrel smoke grenade launcher in 1/35 and 1/16?

Thanks

---

I looked into it and I can't find much in the way of dimensions. The main limit dimension is the angle that the tubes point at.