¹⁄35

New highly detailed MG34 in resin from 1120 Production

This kit is specially produced to fit their Remote Control Mg Mount (item Z-16) but it could also be use on all other panzers as well. Contain twelve resin parts and two Photoetch parts, including brackets for attaching the mg to Stug mg shield.

The barrel, main gun body and ammo cover are produced as one single part. The highly detail barrel jacket (hollow cast), front gun sight base and bipod holding pin are also casted as one single piece.

Both gun sights are separate parts and could be built into up/down position.

The drum magazine is made in slide-open position with a small section of highly detail ammo.

Additional bracket and mounts are provided for attaching the Mg34 to Stug shield as shown below, replacing those from plastic kit.