135
Making A Simple Door

Step 4 : Adding the horizontal planks

Now cut or saw the three horizontal planks needed for our door and glue them into place. Be sure that the inner corners have exact right angles. A tiny difference in angles will show immediately. If your planks dont have exact right angles, then move them in a way that the inner angles are exactly right. The outside of our door can always be sanded or filed into shape...this is much more difficult with the inner sides.

Project Photos
CLICK TO ENLARGE


 

Step 5 : Add the final vertical plank

Now add the other vertical plank. When you follow this sequence, you'll only can end up with one side of the door that needs a bit of work and that is the side of the last plank that you glued on. when you, for example, glue both verticle planks in place first and then try to add the horizontal plankt, you'll find it's very hard to get that right.... you'll have to cut those horizontal planks with a deadly presicion. With the sequence I used there is a bigger margian for error.

At this stage it's time for me to visualize things again... so mr. figure is put next to the door again.... if it looks right, then I go to the final step and if it isn't what I expected...... I destroy the door and start over from step 1 again.

In this example my door looksgood enough and I go to the final step.... the sanding. Sand it very carefully with a very fine grid sandingpaper. Remember...there's Balsa on top and that is very soft... don't sand too hard.

Well, this wraps it up. It's quite easy to make a door of your own. With a bit of patience, some sharp blades and some wood, you'll get there.

Happy Modeling !

Danny "Eagle" Wennekes

Project Photos
CLICK TO ENLARGE

 


 


About the Author

About Danny Wennekes (Eagle)
FROM: NOORD-BRABANT, NETHERLANDS

I started modeling at the age of 10. When I was 22 my work forced me to quit the hobby until I returned to the modeling frontline at the age of 36. Nowadays I model dioramas, but in the land of modeling I admire the figure painters.... so skilled and most of them are great guys too.... My favo...


Comments

Ummm....I have one small question: How do you make doorhandles? I understand that other people may be able to figure it out, but I sure can't. Thanks for your time.
NOV 05, 2003 - 12:51 PM
Well, when I come to detailing, I'll show you how it's done.
NOV 05, 2003 - 06:44 PM
Mebm, That is not so difficult ... Take some solder ( Kan iemand dat ff vertalen ....soldeer draad .. ) and bend that in the appropriate form...Glue is on a small plate for the protection of the door ( see the door handles in your own house ) and add this to the door that Danny discribed and your ready . ( Use super glue to glue the door handle ....) That al there is to it.......... good luck.. Eric
NOV 06, 2003 - 06:22 AM
soldeerdraad = soldering-wire please sir, don't mention it Kris
NOV 06, 2003 - 09:20 AM