1⁄1Cleaning the Iwata hp-cs
4
Comments
B: Using a brush. insert the brush into the needle way, and clean in circular motions.
Then, insert the brush through the paint cup and clean the needle way from this angle, again in circular motions.
Next, dip a Q-tip in thinner, and clean the inside of the paint cup (yep, again, in circular motions).
Now, cleaning of the nozzle and the head cap. Again, you can use either pipe cleaner or brush, and same caution in regards to the pipe cleaner should be exercised.
A: Using a pipe-cleaner. Insert it into the nozzle, and rub it from within, as shown by the arrows.
B: Using a brush. Insert the brush, and rub the nozzle from within in circular and going and out-going motions, as shown by the arrows
Comments
A very thorough 'how to' here...
I've had my CS for about 2 years, but how do you remove the nozzle? I didn't even know it could be done
MAY 25, 2010 - 12:34 AM
just pull it out gently. if it's stuck, gently and carefully tilt it to the sides and pull.
MAY 25, 2010 - 02:34 AM
I missed this until now Matan. This is a very thorough how too great work.
JUN 29, 2010 - 09:47 AM
Copyright ©2021 by Matan Ram. Images and/or videos also by copyright holder unless otherwise noted. The views and opinions expressed herein are solely the views and opinions of the authors and/or contributors to this Web site and do not necessarily represent the views and/or opinions of Armorama, KitMaker Network, or Silver Star Enterrpises. All rights reserved. Originally published on: 2010-05-25 00:00:00. Unique Reads: 19119